This is a 3D print add-on and not an original part from Ravensburger!

With the rail extender, two rails can be practically connected to each other.

To do this, simply press the rails into the openings provided on both sides. Works best if the rail is set at an angle from the outer edge and then pressed tightly inward.

Hints:

The connection is stable, but the rail starts to vibrate due to the ball. The balls must also not roll too slowly, otherwise they can get stuck on the (design-related) small edges. Theoretically, even more rails can be connected with several rail extenders for GraviTrax, but then it becomes unstable. Many balls at the same time naturally cause the rail to bend due to the weight, which must be taken into account when building.

Scope of delivery:

1x Rail-Extender